PIN 3309683 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7573     Link Bracket     2    Start By:
Remove the engine compartment shield. Refer to Disassembly and Assembly, "Engine Compartment Shield - Remove and Install".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01175832
Remove bolts (1) and braces (2) from both sides.
Illustration 2 g01175833
Disconnect hose assembly (4), clips (3), and clips (5) .
Illustration 3 g01175834
Disconnect hose (6) .
Remove bolts (7) .
Illustration 4 g01175835
Remove clip (10) and bolts (9) in order to remove radiator top tank (8) .
Illustration 5 g01175837
Attach Tooling (A) and a suitable lifting device to fan group (12). The weight of fan group (12) is approximately 82 kg (180 lb).
Remove bolts (11) and fan group (12) .