3325189 PIN AS Caterpillar parts
349E, 349E L, 349E L HVG, 349E L VG, 349F L
Rating:
Alternative (cross code) number:
CA3325189
332-5189
3325189
CA3325189
332-5189
3325189
Weight: 257 pounds 116 kg.
EXCAVATOR, MOBILE HYD POWER UNIT,
Compatible equipment models: 3325189:
Number on catalog scheme:
9
For full view, you need register
Information:
Illustration 1 g01999936
Schematic of the "Lift Lever Position" Sensor
This diagnostic code is associated with the "Lift Lever Position" Sensor. The FMI 04 diagnostic code means that the Implement ECM has determined that the voltage of the circuit for the position sensor is below normal.The output frequency of the position sensor is approximately 500 hertz. The duty cycle of the signal changes as the position sensor moves. The duty cycle varies from 8.5 to 91.5%.Ensure that the diagnostic code of CID0352 FMI 04 is active before performing this procedure.The possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is shorted to ground.
The sensor has failed.
The ECM has generated this diagnostic code in error.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code occurs, the lift function will be disabled until the diagnostic code is cleared. Also, the lift lever must be recentered.Test Step 1. CHECK THE SENSOR
Turn the disconnect switch and the key start switch to the ON position.
Ensure that the diagnostic code is active.
Observe the status of the diagnostic code. Disconnect the sensor from the machine harness. Expected Result:The CID 0352 FMI 04 diagnostic code remains active.Results:
OK - The diagnostic code remains active. The sensor is correct. Proceed to Test Step 2.
NOT OK - The diagnostic code is no longer active. The sensor has failed.Repair: Replace the sensor.STOPTest Step 2. CHECK THE WIRING HARNESS OF THE SENSOR FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the sensor.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector for the ECM, measure the resistance from the signal contact J2-24 (wire H710-PK(Pink)) of the machine harness to all possible sources of ground. Measure the resistance to all contacts of the machine harness connectors for the Implement ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - One or more resistance measurements is not correct. There is a short in the machine harness.Repair: The short is between signal contact J2-24 (wire H710-PK(Pink)) and the circuit with the low resistance measurement. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS
Inspect the contacts of the harness connectors and clean the contacts.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0352 FMI 04 diagnostic code. Expected Result:The CID 0352 FMI 04 diagnostic code is active.Results:
YES - The CID 0352 FMI 04 diagnostic code is active. The diagnostic code has not been corrected. The ECM may have generated this diagnostic code in error.Repair: Exit this procedure and perform this
Caterpillar parts catalog:
Parts pin Caterpillar catalog:
324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325D, 325D L, 326D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2...
115, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325B L, 325C, 325D, 325D L, 326D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330, 330 FM L, 330 L, 330B, 330B L, 330C, 330C L, 330D, 3...
324D, 329D LN, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E L, 336E LN, 336F L, 340D L, 340D2 L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L,...
324D, 329D LN, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E L, 336E LN, 336F L, 340D L, 340D2 L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L,...
324D, 329D LN, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E L, 336E LN, 336F L, 340D L, 340D2 L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L,...
324D, 329D LN, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E L, 336E LN, 336F L, 340D L, 340D2 L, 345B II, 345B L, 345C, 345C L, 345D, 345D L, 345D L VG, 34...
324D, 330B L, 330C, 330C L, 330D, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E L, 336E LN, 336F L, 340D L, 340D2 L, 345B II, 345B L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, ...
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 374D L, 374F L, 385C, G107B, PIN GRAB
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 374D L, 374F L, 385C, PIN GRAB
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 385C
345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B, 365B II, 365B L, 365C, 365C L, 385C
345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 365B
2485978
PIN
336E
336E
4190985
PIN AS
16M
16M
4309577
PIN AS
16M
16M
3993125
PIN
HM825, MD-250
HM825, MD-250
4166982
PIN-SPRING
HM825, MD-250
HM825, MD-250
345B II, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, W345C MH
3913850
PIN
HYDRAULIC
HYDRAULIC
3913835
PIN
HYDRAULIC
HYDRAULIC
3913825
PIN AS
HYDRAULIC
HYDRAULIC
3913824
PIN AS
HYDRAULIC
HYDRAULIC
1858079
PIN
HYDRAULIC
HYDRAULIC
3506311
PIN AS
349E, 349E L, 349E L HVG, 349E L VG, 349F L
349E, 349E L, 349E L HVG, 349E L VG, 349F L