PIN AS 3336650 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Note: The ride control diverter valve is located inside the front loader frame.
Illustration 1 g00402000
Disconnect three tube assemblies (1) from diverter valve (3) .
Disconnect electrical connector (2) from diverter valve (3) .
Illustration 2 g00402339
Disconnect hose assemblies (5) and (7) .
Disconnect tube assembly (6) .
Disconnect electrical connector (8) .Note: Use two people in order to remove diverter valve (3). The weight of diverter valve (3) is 27 kg (60 lb).
Remove four bolts (4) from diverter valve (3). Remove the ride control diverter valve (3) .