PIN AS 3455792 - Caterpillar

TARGET="_parent">Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Transmission Oil Filter - Replace
Every 250 Service Hours or Monthly
Axle Oscillation Bearings - Lubricate
Battery - Clean
Belts - Inspect/Adjust/Replace
Braking System - Test
Differential and Final Drive Oil Level - Check
Engine Oil (High Speed) and Oil Filter - Change
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Steering Cylinder Bearings - Lubricate
Initial 500 Service Hours
Seat Side Rails - Adjust
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours or 3 Months
Cooling System Coolant Sample (Level 1) - Obtain
Differential and Final Drive Oil Sample - Obtain
Drive Shaft Spline (Center) - Lubricate
Engine Crankcase Breather - Clean
Fuel System Primary Filter - Clean/Replace
Fuel System Secondary Filter - Replace
Fuel Tank Cap and Strainer - Clean
Hydraulic Fan Valve Screen - Replace
Hydraulic System Oil Filter (Implement Pilot) - Replace
Hydraulic System Oil Filter (Steering Pilot) - Replace
Hydraulic System Oil Sample (Implement and Hydraulic Fan) - Obtain
Hydraulic System Oil Sample (Steering and Brake) - Obtain
Transmission Oil Filter - Replace
Transmission Oil Sample - Obtain
Every 1000 Service Hours or 6 Months
Articulation Bearings - Lubricate
Battery Hold-Down - Tighten
Bucket Stops - Inspect
Drive Shaft Support Bearing - Lubricate
Rollover Protective Structure (ROPS) - Inspect
Transmission Oil - Change
Every 2000 Service Hours or 1 Year
Brake Accumulator - Check
Cooling System Coolant Sample (Level 2) - Obtain
Differential and Final Drive Oil - Change
Hydraulic System Oil (Implement and Hydraulic Fan) - Change
Hydraulic System Oil (Steering and Brake) - Change
Hydraulic Tank Breaker Relief Valve - Clean
Every 3000 Service Hours or 2 Years
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 4000 Service Hours or 2.5 Years
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Hydraulic System Oil (Implement and Hydraulic Fan) - Change
Hydraulic System Oil (Steering and Brake) - Change
Every 5000 Service Hours or 3 Years
Alternator - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Engine Water Pump - Inspect
VIMS Module Battery - Replace
Every 7500 Service Hours or 757 000 L (200 000 US gal) of Fuel
Engine Components - Rebuild/Install Reman
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Cooling System Water Temperature Regulator - Replace
Every 15 000 Service Hours or 1 514 000 L (400 000 US gal) of Fuel
Engine Components - Clean/Inspect, Rebuild/Install Reman, Install New