PIN & SEAL GP-LINKAGE 3474907 - Caterpillar

Illustration 17 g00386359
Install diagnostic connector (37) with lockwasher (38) and a nut.
Illustration 18 g00386360
Install circuit breaker (41) with two screws (42) .
Illustration 19 g00386366
Install connector (43) to starter relay (33) .
Install fuse holders (39) with nut (40). Tighten nuts to a torque of 1.0 0.2 N m (0.74 0.15 lb ft).
Illustration 20 g00386594
Attach fuse holders (44) and wires.
Illustration 21 g00386595
Attach wires (45) to circuit breaker (41) .
Illustration 22 g00386596
Attach wires (46) to starter relay (33) .
Illustration 23 g00386598
Attach wires (47) to main circuit breaker (35) .
Illustration 24 g00386599
Install ground stud (48) .
Install wires (49) to ground stud (48) .
Illustration 25 g00386600
Make the remaining connections for the instrument panel.
Illustration 26 g00386601
Use six allen head screws (49) in order to install dash panel (50) .
Illustration 27 g00386602
Install two rubber grommets (51) and two rubber grommets (52) .
Illustration 28 g00386603
Connect the wiring harnesses to the frame with the tie straps.
Illustration 29 g00386915
Install handle (53) on the right side and left side of the dash panel with two bolts (54) and washers.
Illustration 30 g00386917
Install base (55) for the air filter indicator.
Illustration 31 g00386921
Install air filter indicator (56) .End By: Install the dash panel. Refer Disassembly and Assembly, "Dash Panel - Install".