PIN 3593853 - Caterpillar

Personal injury can result from air pressure.Personal injury can result without following proper procedure. When using pressure air, wear a protective face shield and protective clothing.Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes.
Personal injury or death can result from engine overspeed.If the engine overspeeds, it can cause injury or parts damage.Be prepared to stop the engine by closing the air off to the air inlets or by manually pushing downward on the governor shutdown rod.
Personal injury or death can result from a fire.Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system.Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.
Do not fill fuel filter with fuel before installing the fuel filter. Contaminated fuel causes accelerated wear to fuel system parts.
Note: In order to reduce contamination in the system, do not remove the primary fuel filter and the secondary fuel filter simultaneously. Perform these operations separately.Note: After the engine has stopped, you must wait for 60 seconds in order to allow the fuel pressure to be purged from the high pressure fuel lines before any service or repair is performed on the engine fuel lines.
Illustration 1 g01258157
Open the access door on the front of the engine compartment.
Turn the fuel supply valve (if equipped) to the OFF position before you perform this maintenance.
Place a suitable container under the water separator in order to catch any fuel that might spill. Clean up any spilled fuel. Clean the outside of the water separator.
Illustration 2 g01289897
Install a suitable tube onto the drain (1). Open the drain. Allow the fluid to drain into the container. Remove the tube.
Tighten the drain by hand pressure only.
Unscrew the bowl (2) from the primary filter (3).
Use a Caterpillar strap wrench in order to remove the filter. Discard the old seals and the canister in a safe place.
Clean the bowl.
Install a new filter.
Apply a thin coat of oil to the seal on the new filter.
Install a new filter hand tight until the seal of the filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base. Note: There are rotation index marks on the filter that are spaced 90 degrees or 1/4 of a turn away from each other. When you tighten the filter, use the rotation index marks as a guide.
Tighten the filter according to the instructions that are printed on the filter. Use the index marks as a guide. For non-Caterpillar filters, use the instructions that are provided with the filter. Note: You may need to use a Caterpillar strap wrench, or another suitable tool, in order to turn the filter to the amount that is required for final installation. Make sure that the installation tool does not damage the filter.
Screw the bowl onto the primary filter.
Turn the fuel supply valve (if equipped) to