AVSPARE.COM
parts catalog

PIN-YM 3727510 - Caterpillar



3727510 PIN-YM Caterpillar parts PIN
Rating:
64
Alternative (cross code) number:
CA3727510
372-7510
3727510
Caterpillar 3727510 PIN-YM
Weight: 32 pounds 14 kg.

Buy PIN-YM 3727510 Caterpillar genuine, new aftermarket tractor parts with delivery

Related part:
1066878  PIN-YM  3727510  CL

You can buy parts: .

$9.15

19 Jun 2020
1.0[0.45] Pounds
D&D PowerDrive 3727510 Gmc General Motors Corp Replacement Belt, 41.27"
Belt 17.53 x 41.27in OC || Material type- rubber || Manufactured by D&D PowerDrive
  For full view, you need register

Information:


At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Lower the bulldozer and the ripper to the ground.
Illustration 1 g01321384
Typical example
Slowly remove the hydraulic tank filler cap (1) in order to relieve the pressure in the hydraulic oil system.
Illustration 2 g01194147
Remove the filter element (2) . Properly discard the filter element.Apply a thin coat of oil to the seal on the new filter.
Install the filter element by hand. When the seal contacts the base, tighten the nut with an additional 3/4 turn.
Remove the retainer ring from the oil filler tube.
Remove the strainer from the oil filler tube.
Wash the screen in a clean nonflammable solvent.
Inspect the seal on the filler cap. Replace the seal if the seal is worn or if the seal is damaged.
Install the strainer, the retainer ring, and the cap.
Illustration 3 g01194009
Typical example
Maintain the hydraulic oil to the "FULL" mark in the sight gauge.Replace the Case Drain Filter
Illustration 4 g03640799
Open the access door on the right side of the machine.
Illustration 5 g01604335
Use a strap type wrench to remove the filter element. Dispose of the used filter element properly.
Clean the filter mounting base. Make sure that all of the used gasket is removed.
Apply a thin coat of oil to the seal on the new filter. Install a new hydraulic oil filter by hand.Note: Instructions for the installation of the filters are printed on the side of each Caterpillar spin-on filter. For non-Caterpillar filters, refer to the installation instructions that are provided by the supplier of the filter.


Parts pin Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.