AVSPARE.COM
parts catalog

PIN AS-YM 3960668 - Caterpillar



3960668 PIN AS-YM Caterpillar parts PIN
Rating:
64
Alternative (cross code) number:
CA3960668
396-0668
3960668
Caterpillar 3960668 PIN AS-YM
Weight: 26 pounds 11 kg.

Buy PIN AS-YM 3960668 Caterpillar genuine, new aftermarket tractor parts with delivery

Related part:
5T8654  PIN AS-YM  3960668  CL
  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8T-3207 Lift Bracket 1
5P-8622 Shackle 1
9S-9076 Spacer 2
B 1P-510 Driver Group 1 Start By:
Remove the outer axles. Refer to Assembly and Disassembly, "Axle - Remove and Install".
Illustration 1 g00744820
Remove three evenly spaced bolts (2) from the final drive planetary carrier (3). Install three 20 mm bolts that are 100 mm in length (1).
Remove the remainder of the shorter bolts (2). Slide the final drive planetary carrier on bolts (1).
Illustration 2 g00744822
Adjust bracket (4) on Tooling (A) until dimension (X) is 254 mm (10 inch).
Illustration 3 g00744823
Fasten a suitable lifting device and Tooling (A) to the final drive planetary carrier. Remove three bolts (1) and final drive planetary carrier (3). The weight of the final drive planetary carrier is 98 kg (215.0 lb).
Remove the O-ring seal from final drive planetary carrier (3).
Illustration 4 g00744824
If necessary, remove seal (4) from the spindle. Note: If you need to disassemble the planetary carriers, refer to Disassembly and Assembly, "Final Drive - Disassemble".Installation Procedure
Illustration 5 g00744865Note: O-rings, gaskets, and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring or a gasket. Use 1U-6396 O-Ring Assembly Compound during the assembly procedure.
If seal (4) was removed, use Tooling (B) and install seal (4) in the spindle. Install the seal with the lip of the seal toward the spindle.
Illustration 6 g00744823
Install the O-ring seal on final drive planetary carrier (3).
Fasten a suitable lifting device and Tooling (A) to final drive planetary carrier (3). Put the final drive planetary carrier in position in the final drive housing. Install three evenly spaced 20 mm bolts that are 100 mm in length (1).
Illustration 7 g00744820
Install bolts (2) that hold final drive planetary carrier (3) in position.
Remove three bolts (1), and install the remaining bolts (2). End By:
Install the outer axles. Refer to Disassembly and Assembly, "Axle - Remove and Install".


Parts pin Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.