PIN-TRACK 3P3880 - Caterpillar

Specify the Orientation of the Arm Sensor
Before the arm sensors can be used, you must specify the segment of the arm each sensor is mounted on. Only one arm sensor at a time can be connected to the system harness during the configuration procedure. Ensure that only one sensor is connected to the harness during the configuration. Failure to connect only one Angle Sensor at a time could render the sensors unusable.
Make sure that you complete this process before you calibrate the arm sensors. If you do not set the sensor orientations correctly, future calibration results will be invalid and bucket guidance will be inaccurate.
Note: The orientation of an arm sensor describes the side of the arm that the sensor is mounted on.In order to set the orientation of the arm sensor, complete the following steps:
Press the "Setup Menu" soft key.
Press the "Installation" soft key.
Illustration 1 g01453749
Use the arrow keys in order to highlight "Calibrate Sensors". Press the "OK" key.
A screen that is similar to Illustration 2 will appear.
Illustration 2 g01217606
Use the up arrow button or the down arrow button in order to highlight "AS300C Sensor Orientations". Press the "OK" key.
A screen that is similar to Illustration 3 will appear.
Illustration 3 g01348929
Use the soft keys in order to set the orientation to the "Left" for all of the sensors that are not set to "Left".Note: Press the soft key for any of the sensors, in order to change the orientation for that sensor from "Left to Right" or from "Right to Left".
Press the "OK" key when the sensors for the boom, the stick and the bucket are oriented correctly. The display will return to the "Calibrate Sensors" screen.Calibrate Sensors
Calibrate the Pitch Sensor
Ensure that this procedure is completed before you start the GPS Measurements procedure. If the pitch sensor is not calibrated correctly, calibration of the other system components cannot be done accurately.
Note: In order to perform the calibration for the pitch sensor, the GPS receivers must be installed and configured.The calibration procedure for the pitch sensor is used in order to estimate the errors and offsets in the pitch values returned by the pitch sensor.
Park the excavator on flat ground.Ensure that the location has a clear view of the sky. Ensure that the excavator can be rotated 180° without moving the tracks.
In order to enter service mode, power up the display while you hold down the "OK" key.
Press the "Menu" key.
From the "Setup Menu - Configuration" screen, select "Installation" (120) .Refer to Illustration 4.
Illustration 4 g01377930
Use the arrow keys in order to select "Calibrate Sensors". Press the "OK" key.Refer to Illustration 5.
Illustration 5 g01380413
From the "Calibrate Sensors" dialog, select "Pitch Sensor Calibration".A screen that is similar to Illustration 6 appears.
Illustration 6 g01347627
Raise the boom and the stick in order to allow for 180 degrees of rotation.
Press the "Calibrate" soft key.A screen that is similar to Illustration 7 will appear.
Illustration 7 g01347631
Rotate the body of the excavator 180 degrees. Do not move the tracks or the boom and stick.
Press the "Calibrate" soft key in order to