PIN 3T7566 - Caterpillar

This diagnostic code is recorded when the diagnostic circuit in the PL522 and 523 identifies a system voltage that is above 32 VDC.The possible causes of this fault are listed below:
A charging system component is faulty.
The harness wiring is faulty.
The PL522 or 523 is faulty. Module failure is unlikely.Note: Determine if a battery charger or a welder is being used on the machine. Disconnect the charger or the welder if one is used. Recheck for the diagnostic code.Test Step 1. CHECK THE SYSTEM VOLTAGE AT THE 70-PIN CONNECTOR OF THE PL522 or 523.
Start the engine and operate the engine at a high idle for 5 to10 minutes.
Measure the system voltage between the "Unswitched Power" and the "Ground" contacts. Pin 52 is the terminal for "Unswitched Power" and pin 65 is the terminal for "Ground". Expected Result:The voltage is 11 VDC to 32 VDC.Results:
OK - The voltage is 11 VDC to 32 VDC. The PL522 or 523 should not be logging this diagnostic code.Repair: Use the Caterpillar Electronic Technician (Cat ET ) in order to clear the diagnostic code from the PL522 or 523. If the voltage is correct and the PL522 or 523 records the diagnostic code again, replace the PL522 or 523. Before replacing the PL522 or 523, contact your Caterpillar Technical Communicator.STOP
NOT OK - The voltage is not 11 VDC to 32 VDC. Proceed to Test Step 2.Test Step 2. CHECK THE ALTERNATOR.
Run the engine at high idle for 5 to 10 minutes.
Measure the voltage output at the battery posts. Expected Result:The voltage should be below 32 VDC.Results:
OK - The voltage is below 32 VDC. The battery could be faulty. Proceed to Test Step 3.
NOT OK - The voltage is above 32 VDC. Troubleshoot the alternator. The voltage regulator could be faulty. If conditions are not resolved, proceed to Test Step 3.Test Step 3. CHECK THE BATTERY VOLTAGE.Turn the key start switch to the OFF position. Measure the battery voltage at the battery posts.Expected Result:The voltage should be below 32 VDC.Results:
OK - The voltage is below 32 VDC. Proceed to Test Step 4.
NOT OK - The voltage is above 32 VDC.Repair: Refer to Special Instruction, REHS0354, "Charging System Troubleshooting".If conditions are not resolved, proceed to Test Step 4.Test Step 4. CHECK EVERY ECM ON THE MACHINE.Check the logged diagnostics of any other ECM that is installed on the machine. Compare each ECM that has logged the "CID 168 FMI 00" code in the same time period. The Service Meter Hours (SMH) on the logs may be different. The difference between the current SMH and the logged SMH is important.Expected Result:Other "CID 168 FMI 00" diagnostic codes can be found on other Electronic Control Modules (ECM).Results:
YES - "CID 168 FMI 00" diagnostic codes are found on other Electronic Control Modules (ECM).Repair: Clear the fault if all the following conditions occur:
A problem is not found with the charging system.
A problem is not found with the wiring.
The fault has occurred a few times.Monitor the module and the machine for