PIN AS 3W7559 - Caterpillar

Engine: C13 (S/N: LEE1-UP) C15 (S/N: SDP1-UP)Introduction
This Special Instruction provides information for the updates to the wires and the harness to the exhaust combustion groups on the Heavy-Duty 2007 engines.Routing for the 289-2515 Exhaust Combustion Gp
Illustration 1 g01371259
(1) 289-2515 Exhaust Combustion Gp
Illustration 2 g01371262
(2) 204-1611 Cable Strap (3) 3S-2093 Cable Strap (4) 3S-2093 Cable Strap
Use 204-1611 Cable Strap (2) in order to tie the sensor back to the line.
Install the strap (3) to both connectors that are on the clip. Install the strap in the grooves of the body of the connector.
Use 3S-2093 Cable Strap (4) to tie the excess wires of the sensor.
Illustration 3 g01371264
(5) 290-1993 Cable Strap Install the strap (5) to the main leg of the harness at the locations that are shown in Illustration 3.
Illustration 4 g01371268
(6) 204-1611 Cable Strap (7) TubeUse strap (6) to tie the sensor to the tube (7).
Illustration 5 g01371278
Approximate orientation of the sensor probe and the boot (8) .
Illustration 6 g02586360
(9) 3S-2093 Cable Strap Attach strap (9) to the existing clip (10) .Updating 289-2724 Exhaust Combustion Gp
Illustration 7 g01371285
(1) 289-2724 Exhaust Combustion Gp
Illustration 8 g01371288
(2) Strap (3) Clip (4) 3S-2093 Cable Strap (5) 290-1993 Cable Strap (6) 285-6393 Clip
Install strap (2) to both connectors on the clip (3) with the strap in the groove of the body of the connector.
Use strap (4) to tie the excess wire from the sensor.
Install strap (5) and clip (6).
Illustration 9 g01371292
(7) 277-1873 Clip (8) 9M-1974 Hard Washer (9) 5P-7970 Nut (10) 3S-2093 Cable Strap (11) 206-6875 Tube Cap (12)