PIN AS 4522743 - Caterpillar

Note: Ensure that the configuration of the harness connector matches the configuration that is provided in Table 4.
Illustration 14 g03541800
(2) 263-5417 Rocker Switch (E) 345-6007 Switch Cover (F) 345-6026 Console As
Reinstall the 345-6007 Switch Cover (E) into the 345-6026 Console As (F) .Machine Configuration
The 388-8269 Self Level Kit is a premium feature that must be configured using the Caterpillar Electronic Technician (CAT ET).
Connect the CAT ET to the machine. Turn the start key to the ON position. Do not start the engine.
Start the CAT ET and select the machine ECM.
From the menu select "Service", then "Configuration".
Illustration 15 g03567413
In the configuration screen, double click on the "Work Tool Self Level System Installation Status" link.
Illustration 16 g03567414
In the Pop-up window, change the New Value field to Installed. Click 'OK'.
Illustration 17 g03567415
Access the CAT Factory Password System (FPS) at https://fps.cat.com.
Enter the required information.
Obtain the passwords and enter them into the appropriate input boxes labeled "Factory Password #1" and "Factory Password #2".
Turn the start key to the OFF position and wait at least 15 seconds. Turn the start key back to the ON position.Note: The new feature will be activated on the next power cycle.
From the menu select "Configuration" and then "Implement Configuration".
Illustration 18 g03567416
In the configuration screen, double click on the "Work Tool Self Level System installation Status". Ensure that the feature is set to "Installed".RTD (Return to Dig) Machine Configuration (Optional)
The 388-8269 Work Tool Positioner (Self Level) Kit can also be configured for the RTD (Return to Dig) feature by using Caterpillar Electronic Technician (CAT ET). This feature consists of two additional modes. "Work Tool Positioner Mode" enables the work tool to automatically return to an operator selectable preset angle. "Return to Dig" enables the work tool to automatically return to an operator selectable preset angle and automatically lowers the lift arms to the stops. Refer to the machine's Operation and Maintenance Manual for more information on using these modes.
Connect CAT ET to the machine. Turn the start key to the ON position. Do not start the engine.
Start CAT ET and select the machine ECM.
Illustration 19 g03572616
From the menu select "Service", then "Configuration".
Illustration 20 g03572617
In the configuration screen, double click on the "Return to Dig Feature Installation Status" link.
Illustration 21 g03572618
In the Pop-up window, change the New Value field to "Installed". Click "OK".
Illustration 22 g03572619
Access the CAT Factory Password System (FPS) at https://fps.cat.com.
Enter the required information.
Obtain the passwords and enter them into the appropriate input boxes labeled "Factory Password #1" and "Factory Password #2".
Turn the start key to the OFF position and wait at least 15 seconds. Turn the start key back to the ON position.Note: The new feature will be activated on the next power cycle.
From the menu select "Service", then "Configuration".
In the configuration screen, double click on the "Return to Dig Feature Installation Status". Ensure that the feature is set to "Installed".