PIN 4809037 - Caterpillar

Illustration 3 g02840857
Front view
Table 2
Specification for 350-5225 Cylinder Block Gp
Item Qty Part Specification Description
4 8 211-7826 Cylinder Block Liner For the correct method of determining height of the liner, refer to Testing and Adjusting, "Cylinder Liner Projection".
5 8 352-6061 Liner Seal Before assembly, cover seals with either P-80 Rubber Lubricant Emulsion or liquid soap.
Assemble dry seals on clean and dry liner grooves.
H - - Bore in the block for the camshaft bearings is 98.000 0.020 mm (3.8583 0.0008 inch).
J - - Oil holes must be positioned from horizontal at angle of 20 5 degrees.
All centerlines through oil holes in the camshaft bearings and bearing junctions must be in the position that is shown for each side of the cylinder block.
6 24 7N-2046 O-Ring Seal Before assembly, cover seals with either P-80 Rubber Lubricant Emulsion or liquid soap.
7 8 6V-3348 O-Ring Seal Before assembly, lightly lubricate the bore with the lubricant that is being sealed.
K - - Bore in the block for the main bearings is 169.742 0.020 mm (6.6827 0.0008 inch).
Illustration 4 g02840858
Right side view
Table 3
Specification for 350-5225 Cylinder Block Gp
Item Qty Part Specification Description
8 4 5F-9657 O-Ring Seal Before assembly, lightly lubricate the bore with 5P-3975 Rubber Lubricant.
L 3 7N-2047 Dowel Extension of dowel from the surface of the cylinder block is 6.0 0.5 mm (0.24 0.02 inch).
M 2 4N-0683 Dowel Extension of dowel from the surface of the cylinder block is 19.0 0.5 mm (0.75 0.02 inch).
N 2 7N-2044 Dowel Extension of dowel from the surface of the cylinder block is 40.0 0.5 mm (1.57 0.02 inch). Camshaft Bearing Position
Illustration 5 g03113600
Left side view of engine
Table 4
Specification for 350-5225 Cylinder Block Gp
Item Qty Part Specification Description
The camshaft bearings are installed into the cylinder block at the following positions:
- - - Distance (A) from rear face of cylinder block is 1120.0 1.5 mm (44.09 0.06 inch).
- - - Distance (B) from rear face of cylinder block is 850.0 1.5 mm (33.46 0.06 inch).
- - - Distance (C) from rear face of cylinder block is 580.0 1.5 mm (22.83 0.06 inch).
- - - Distance (D) from rear face of cylinder block is 310.0 1.5 mm (12.20 0.06 inch).
- - - Distance (E) from rear face of cylinder block is 40.0 1.5 mm (1.58 0.06 inch).