PIN AS-DRAWBAR 4E9153 - Caterpillar

Illustration 1 g01427278
Illustration 2 g01427279There are several specific messages on this machine. The location of the messages and the description of the messages are reviewed in this section. Please become familiarized with all messages.Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall.Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Caterpillar dealer can provide new messages.ELC (1)This message is located underneath the access door for the radiator cap.
Illustration 3 g01211116
When the steering lever is moved with the transmission in NEUTRAL or in gear, and the engine is running, the machine will turn. Engage the steering control lock by engaging the parking brake in order to prevent machine movement.
Air Conditioner (2)This message is located on the heater and air conditioner group underneath the left hand access door.
Illustration 4 g00927763This message for the air conditioner has the appropriate information for the following services: the air conditioner lubricant, the refrigerant charge and the refrigerant capacity.Follow instruction in order to avoid engine damage.Reference: See Operation and Maintenance Manual, "Maintenance Interval Schedule" for all maintenance recommendations.Data Privacy (3)If your machine is equipped with the Product Link System, this additional message is located in the cab on the rear right C post.
Illustration 5 g01418953This film notifies the operator to read the Operation and Maintenance Manual in order to understand the usage of information with the Product Link system, if equipped.