PIN AS 4I4619 - Caterpillar

Conditions Which Generate This Code:The Electronic Control Module (ECM) detects a high engine coolant temperature under the following conditions:
The engine has been running for more than 185 seconds.
The trip point for the event code for the temperature of the engine coolant is reached.
Diagnostic code 0110-03 Engine Coolant Temperature voltage above normal is not active.
Diagnostic code 0110-04 Engine Coolant Temperature voltage below normal is not active.
Diagnostic code 0168-01 Electrical System voltage low is not active.
Table 1
Engine Coolant Trip Level Table    
    E361-1     E361-2     E361-3    
Trip Point    
113 °C (233 °F)    
114 °C (237 °F)    
118 °C (244 °F)    
Delay to Activation     10 seconds     10 seconds     2 seconds    
Reset Time     4 seconds     20 seconds     20 seconds    System Response:If equipped, the warning lamp will come on and the event code will be logged.E361-1NoneE361-2The ECM will derate the power at one percent per second.The derate of the engine will only occur if the "Enable Derate" customer programmable parameter has been enabled.E361-3The ECM will shut down the engine after two seconds when the trip point for the engine coolant temperature has been reached.Note: The shutdown of the engine will only occur if the "Enable Shutdown" customer programmable parameter has been enabled. Test Step 1. Refer to Troubleshooting, "Coolant Temperature Is Too High".Results:
OK - STOP