PIN AS 4T2479 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 6V-4876 Lubricant -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01953297
Loosen the adjustment screws on the rocker arms. This will prevent a bent valve or a bent pushrod during the installation of the rocker shaft assembly. Install pushrods (3) and ensure that the pushrods are seated in the valve lifters.
Install rocker shaft (2) in position on the cylinder head.
Ensure that the dowels on each end of the rocker shaft assembly are in alignment with the holes in the cylinder head.
Illustration 2 g00591852
G3304B torque sequence
Illustration 3 g00544706
G3306B torque sequence
Note: Replace the O-ring seal when the bolt toward the rear of the engine is installed in the rocker shaft support.
Apply Tooling (A) on the threads of bolts (1) except for the bolt that passes through the rear rocker shaft support. Install bolts (1) in the rocker shaft assembly.
Refer to Illustration 2 or Illustration 3. Tighten bolts (1) for the rocker shaft, as follows:
Tighten all of the bolts in a numerical sequence to a torque of 150 15 N m (110 11 lb ft).
Tighten all of the bolts in a numerical sequence