AVSPARE.COM
parts catalog

PIN 4Z8924 - Caterpillar



4Z8924 PIN Caterpillar parts PIN
Rating:
66
Alternative (cross code) number:
CA4Z8924
4Z-8924
4Z8924
Caterpillar 4Z8924 PIN
Weight: 0.05 pounds 0 kg.

Buy PIN 4Z8924 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Start By:
Remove the rear tires.
Personal injury or death can result from improper lifting or blocking.When a hoist or jack is used to lift any part or component, stand clear of the area. Be sure the hoist or jack has the correct capacity to lift a component. Install blocks or stands before performance of any work under a heavy component.Approximate weights of the components are shown. Clean all surfaces where parts are to be installed.
Personal injury can result from driveline torque windup under load.Unequal wheel speed can result in driveline torque windup which can cause driveline components to be under load during disassembly.Relieve the driveline torque windup before disassembly.
Illustration 1 g03865465
Remove guard (1), guard (2), and guard (3).
Illustration 2 g03865467
Disconnect tube (4) and tube (6). Disconnect harness assembly (5).
Illustration 3 g03865472
Remove bolts (7) and use two persons to lower drive shaft (8) onto suitable cribbing. The weight of drive shaft (8) is approximately 43.09105 kg (95 lb).
Illustration 4 g03865474
Disconnect hose assembly (9), hose assembly (10), and hose assembly (11).
Illustration 5 g03865540
Remove nuts (13) and the bolts. Remove nuts (14) and the bolts. Remove rear stabilizer bar (12).
Illustration 6 g03865542
Attach Tooling (A) to rear suspension group (13) and to the back half of rear frame suspension (14).
Illustration 7 g03865543
Install Tooling (C) and a suitable lifting device to rear axle assembly (15). The weight of rear axle assembly (15) is approximately 2177 kg (4800 lb). Repeat for the other side of rear axle assembly (15)
Illustration 8 g03865659
Install Tooling (D), Tooling (E), and Tooling (F) to yoke assembly (16). This will prevent the rear axle assembly from rotating downward.
Illustration 9 g03865628
Remove bolts (18) and use two persons to remove bracket (17). The weight of bracket (17) is approximately 34 kg (75 lb)
Illustration 10 g03865627
Remove bolts (19).
Illustration 11 g03865775
Use Tooling (C) and the suitable lifting device to lower rear axle assembly (15) onto Tooling (B). Installation Procedure
Install rear axle assembly (10) in the reverse order of removal.
Tighten bolts (7) to a torque of 117 10 N m (86 7 lb ft).


Parts pin Caterpillar catalog:

4Z8923 PIN
Caterpillar
4Z8676 PIN
Caterpillar
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.