PIN AS-YM 5159312 - Caterpillar

Adjustment Procedure:
1. Loosen nuts (2).2. Remove cotter pins and pins that connect rod ends (3) to levers (5).3. Move rods (1) all the way toward the front of the machine, until levers (5) are against bumpers (4).4. Make an adjustment to rod ends (3), so that distance (A) between the centerline of the handles on rods (1) and the face of the dash is ... 4.21 in.(107.0 mm)5. Install the pins and cotter pins that connect rod ends (3) to levers (5).6. Tighten nuts (2) to a torque of ... 75 10 lb. ft.(100 14 N m)7. Loosen nuts (7).8. Remove the cotter pins and pins that connect rod ends (8) to levers (13).9. Make an adjustment to rod ends (8), so that distance (B) between the centerline of the pins is ... 21.65 in.(550.0 mm)10. Install the pins and cotter pins that connect rod ends (8) to levers (13).11. Tighten nuts (7) to a torque of ... 9 3 lb. ft.(12 4 N m)12. Loosen nuts (10).13. Remove the cotter pins and pins (12) that connect rod ends (11) to levers (13).14. Pull rods (9), one at a time, toward the front of the machine until a resistance is felt.15. Make an adjustment to rod ends (11), one at a time, so pins (12) can be installed through the rod ends into levers (13).16. Turn rod ends (11), one at a time, 1/2 turn so the length of rods (9) is made shorter.17. Put rod ends (11) in position on levers (13) and install pins (12) and cotter pins.18. Tighten nuts (10) to a torque of ... 9 3 lb. ft.(12 4 N m)