PIN AS 5214176 - Caterpillar

Illustration 1 g01385028
(1) Torque for the bolt ... 37 4 N m (27 3 lb ft) (2) 6N-1069 Spring Length under test force ... 33.96 mm (1.337 inch) Test force ... 26.01 1.30 N (5.8 0.3 lb) Free length after test ... 53.52 mm (2.107 inch) Outside diameter ... 10.31 mm (0.406 inch)Fuel pressure that is needed to open the valve plunger assembly ... 230 kPa (33 psi) (3) Transfer pump cover (A) Install the lip type seal to the following depth from the top of the transfer pump cover. ... 22.61 0.05 mm (0.890 0.002 inch) (B) Clearance between transfer pump gear and fuel transfer pump body ... 0.8 0.5 mm (0.03 0.02 inch)Note: The shaft assembly must rotate freely after the cover bolts are tightened. (4) Lubricate the lip type seal lightly with the lubricant that is being sealed. (5) Install the idler shaft within the following distance from the edge of the fuel transfer pump body. ... 0.25 mm (0.010 inch) (6) Lubricate the bore for the O-ring seal lightly with the lubricant that is being sealed. (7) Inside diameter of the sleeve bearing after assembly ... 12.581 0.013 mm (0.4953 0.0005 inch) (C) Install the bottom of the upper lip type seal to the following dimension from the bottom of the fuel transfer pump body. ... 26.19 0.13 mm (1.031 0.005 inch) (D) Install the bottom of the lower lip type seal to the following dimension from the bottom of the fuel transfer pump body. ... 14.2 0.5 mm (0.56 0.02 inch) (8) Torque for the locknut ... 30 7 N m (22 5 lb ft)
Illustration 2 g01024390
(E) Install the ferrule to the following dimension from the top of the fuel transfer pump body. ... 5.6 0.5 mm (0.22 0.02 inch)When testing the fuel transfer pump is using diesel fuel, the pump should be within the following specifications:
Run the pump at 1050 rpm. Adjust the flow to 2.5 L/min (0.7 US gpm). The full bypass pressure should be 192 73 kPa (28 11 psi).
Run the pump at 750 rpm. Adjust the flow to a minimum of 2.3 L/min (0.6 US gpm). The minimum pressure should be 135 kPa (20 psi).
Run the pump at 750 rpm. Block the fuel flow at the outlet. The pump pressure should be 230 35 kPa (33 5 psi).
Run the pump at 300 rpm. Adjust the pump pressure to 140 kPa (20 psi). The minimum flow should be 1 L/min (0.3 US gpm).When the pump is viewed from the drive end the rotation of the pump is counterclockwise.
Illustration 3 g01385611
(9) Bore in shaft bearing after installation ... 11.961 0.033 mm (0.4709 0.0013 inch)