PIN 5299284 - Caterpillar

Place the system in test mode by removing "test mode" plug (1). Make sure that the parking brake is in the ON position.Note: On CB-564D machines, remove the "model config" plug. The plug is located near the fuse box. On some machines, the side console cover may need to be removed in order to access the plug. The plug should then be moved to a more accessible location for future service.
Turn the key to the ON position. Do not start the engine.
If there are any fault codes, do not proceed to the next step. A series of long flashes and short flashes of the light for the parking brake will indicate fault codes. Refer to Table 1 for the fault codes.
Table 1
Fault Code    Fault Code    
11     Brake Switch    
12     Propel Control Handle    
13     Speed Control    
14     Solenoid for the Forward EDC    
15     Solenoid for the Reverse EDC    
16     Calibration of the Propel Control Handle    
17     Calibration of the Speed Control    
18     Calibration of the Forward EDC    
19     Calibration of the Reverse EDC    
22     Offset Switch    
28     CCW Offset    
29     CW Offset    
31     Brake Solenoid    
32     Solenoid of the Valve for the Shunt    
41     Water Timer    
42     Calibration of the Water Timer    
43     Water Mode    
44     Water Switch ON Position    
51     Propel Mode    
52     Neutral Fault    
53     Machine Type    
54     Backup Alarm    
55     Neutral    
61     Vibe Configuration    
62     Vibe Forward    
63     Vibe Reverse    
64     Vibe Hi/Lo    
91     Sensor Power    
Illustration 2 g01531573
Squeeze tabs (A) in order to release the connector.
Disconnect the sensor for the propel control handle from harness (2) and connect harness (2) within 5 seconds. This will initiate calibration of the propel control handle.
Move the propel control handle to the Full Forward position.
Illustration 3 g01562795
Press button (3) .
Move the propel control handle (4) to the full REVERSE position.
Press button (3) .
Move the propel control handle (4) to the NEUTRAL position.
Press button (3) .
The light for the parking brake switch will flash twice in order to confirm that the calibration was accepted.Note: If calibration is not successful a fault code will be displayed on the light for the parking brake switch. If the calibration is not successful, cycle the power with the key and attempt the calibration again.Note: If a calibration fault cannot be remedied by repeating the calibration procedure, restore the default calibration values. All calibrations on all calibrated sensors will need to be repeated. Perform the following steps in order to reset the fault history, the timers, and the calibration values.
Illustration 4 g01562814
Select "New System" (5), "Parameter Functions" (6), and "Defaults" (7) in the "Diagnostic Navigator" tree structure.
Enter a "0" in the "Value" cell of the desired row.
Click "Download".
Click "OK" on