PIN 5E9892 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Parts Section
Table 1
467-4021 Coupler Control Ar Revision -01    
Qty    Part Number    Description    Media    
1    458-7474     Chassis Wiring Gp     GEHS0962    
1    458-3791     Front Lines Gp     GEHS0961    
1     467-4022     Front Lines Gp     GEHS0963    
1     364-0375     Cab Wiring Gp     GEHS0716    
1     343-8342     Hydraulic Lines Kit     REHS3854    
1     448-4756     Film Gp     --    Installation of the 448-4756 Film Gp
Illustration 2 g02454257
Left side view of the cab (1) 268-4531 Film (2) 268-8872 Film (For U.S) (2) 269-0121 Film (For INTL) Tuning Section
Updating ECM Settings: Reference the following description for selecting the proper "Quick Coupler Configuration". There are either one or two parameters to update, depending on the machine software and system installed.
Parameter: "Quick Coupler Installation Status" (ET) "Quick Coupler" (Monitor)
Not Installed: "Quick Coupler" control system is not installed on the machine.
Installed without Coupler Accelerator: This setting is the traditional North American setting that only applies voltage to the coupler valve when the switch is flipped. This