PIN GP 5W6151 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining and filling procedures.
Illustration 1 g03844941
Remove bolts (1), elbow (3), and tube assembly (2).
Illustration 2 g03844972
Remove strap (10) and move harness assembly (7) out of the way.
Remove bolts (4), bolts (6), bolts (8), clamps (9), and tube assembly (5).
Illustration 3 g03845008
Disconnect hose assembly (11), tube assembly (12), and tube assembly (13).
Illustration 4 g03845022
Remove bolts (14) and fuel transfer pump (15).
Illustration 5 g03845035
Remove bolts (18), bolt (17), and elbow (16).
Illustration 6 g03845040
Use a suitable lifting device to remove engine oil cooler (20). The weight of engine oil cooler (20) is approximately 208 kg (459 lb).
Remove bolts (19), bolts (21), and engine oil cooler (20). Installation Procedure
Install engine oil cooler (20) in the reverse order of removal.
Lubricate the bore of tube assembly (5) with the fluid that is being sealed.
Install clamps (9) to tube assembly (5). Hand tighten bolts (6) and bolts (8). Tighten bolts (6) to a torque of 47 9 N m (35 7 lb ft). Tighten bolts (8) to a torque of 47 9 N m (35 7 lb ft).
Lubricate the bore of tube assembly (2) with the fluid that is being sealed.