PIN 6G0607 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 207-1601 Rubber Lubricant - Start By:
Remove diesel exhaust fluid module.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03375189Note: Do not attempt to pry or pull the tabs out of the connections on hose assemblies (4) as damage will occur. Push down on the fitting and push the tabs inward before pulling up in order to disconnect hose assemblies (4).
Clamp off hoses (3).
Remove clips (1) and (5). Disconnect harness assemblies (2). Remove hose assemblies (4) and hoses (3).
Illustration 2 g03375204
Remove cable straps (6) and disconnect harness assembly (7).
Illustration 3 g03375207
Remove bolts (8), plate (9), manifold (10) and the gasket (not shown).
Illustration 4 g03382988
Arrow indicates the direction to remove filter assembly (11).
Illustration 5 g03375411Note: To remove filter assembly (11) from manifold assembly (10), pull outward on tabs (12).
Remove filter assembly (11) from manifold assembly (10). Installation Procedure
Install manifold (10) in reverse order of removal.
Tighten bolts (8) in an alternating sequence to a torque of 5 1 N m (44 9 lb in). Tighten bolts (8) a second time in an alternating sequence to a torque of 5 1 N m (44 9 lb in).
Apply Tooling (A) to the O-ring seal inside hose assemblies (5).