PIN 6K3937 - Caterpillar

Governor Minimum Stability Factor #1
This parameter is used by the ECM to offset the steady state speed error when the steady state speed error is less than 20 rpm.
Table 44
Minimum Default Maximum
0 598 65535 Governor Maximum Stability Factor #1
This parameter is used by the ECM to offset the steady state speed error when the steady state speed error is greater than 20 rpm.
Table 45
Minimum Default Maximum
0 1197 65535 Engine Coolant Temperature Control Module Installation Status
This parameter is used to program the installation status of the TCM for the engine cooling system.
Table 46
Options Default
Installed
Not Installed Installed Desired Engine Coolant Temperature Configuration
This parameter is used to program setting for coolant temperature that will be used by the TCM for the engine.
Table 47
Minimum Default Maximum
40 85 102 Aftercooler Temperature Control Module Installation Status
This parameter is used to program the installation status of the TCM for the aftercooler cooling system.
Table 48
Options Default
Installed
Not Installed Not Installed Desired Engine Aftercooler Coolant Temperature Configuration (Petroleum Application)
This parameter is used to program setting for coolant temperature that will be used by the TCM for the aftercooler.
Table 49
Minimum Default Maximum
0 48 102 Desired Engine Aftercooler Coolant Temperature Configuration (Marine Application)
This parameter is used to program setting for coolant temperature that will be used by the TCM for the aftercooler.
Table 50
Minimum Default Maximum
0 40 102 Exhaust Temperature Module Installation Status
This parameter defines the installation status of the exhaust temperature module.
Table 51
Options Default
Installed
Not Installed Installed Full Load Setting (FLS)
FLS represents the adjustment to the fuel system that was made at the factory in order to fine-tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.
Table 52
Minimum Default Maximum
−128 0 127 Full Torque Setting (FTS)
FTS is like FLS. Only change this value if the engine is rerated or if a new ECM has been installed. Factory passwords are required to change this parameter.
Table 53
Minimum Default Maximum
−128 0 127 Security Access Parameters
Total Tattletale
The total tattletale counts the number of changes that are made to the system parameters.