PIN (6.48" long) 6K8544 - Caterpillar

Remove And Install Oil Filter Housing
1. Drain oil from the oil filter housing. 2. Remove bolts (2) and two nuts (3) from studs. Remove cover (4).3. Remove bolt and clamp (5) from manifold bracket.4. Remove two bolts (1) and clip from housing.5. Remove clamp from opposite end of tube assembly (6). Indicator assembly must be removed to install tool (A). 6. Remove indicator assembly (7) from housing. Remove nut and bolt (8) that is used to fasten clip to bracket.7. Install a hoist and tooling (A) on oil filter housing. 8. Remove four bolts (9) and oil filter housing (10) from engine. Weight of oil filter housing is 115 lb. (52 kg).9. The following steps are for the installation of the oil filter housing.10. With tool (A) and a hoist on housing (10), put in position and install four bolts (9). Install bolt (8) in brackets. Remove tool (A) and install indicator assembly (7). 11. Put engine oil on O-ring seal (11) and install tube assembly (6) in housing. Install clip and bolts (1). Install bracket (5).12. Inspect and make a replacement of gasket (12) if necessary. Install cover (4) in position.13. Check oil level in the crankcase. Fill to the correct level.