PIN 7N9806 - Caterpillar

Electronic Modular Control Panel 4.2B (EMCP 4.2B) (If Equipped)
Illustration 1 g02082653
EMCP 4 Control System Panel
(1) Display screen
(2) AC overview key
(3) Engine overview key
(4) Main menu key
(5) Alarms acknowledge key
(6) Reset event key
(7) Event log
(8) Run key
(9) Auto key
(10) Stop key
(11) Escape key
(12) Up key
(13) Right key
(14) OK/Enter key
(15) Down key
(16) Left keyNavigation Keys
AC Overview (2) - The "AC OVERVIEW" key will navigate the display to the first screen of AC information. The "AC OVERVIEW" information contains various AC parameters that summarize the electrical operation of the generator set.Engine Overview (3) - The "ENGINE OVERVIEW" key will navigate the display to the first screen of engine information. The "ENGINE OVERVIEW" information contains various engine parameters that summarize the operation of the generator set.Main Menu Key (4) - The "MAIN MENU"key will navigate the display to the main menu directly without having to navigate out of menus.Acknowledge Key (5) - Pressing the "ACKNOWLEDGE" key will cause the horn relay to turn off. The horn relay being turned off will silence the horn. Pressing the "ACKNOWLEDGE" key will also cause any red or yellow flashing lights to either turn off or to come on continuously. The "ACKNOWLEDGE" key will also send out a global alarm silence signal on the J1939 Data Link. Annunciators on the J1939 Data Link can be configured to silence their individual horns upon receipt of the global acknowledge.Reset Key (6) - Pressing the "RESET" key will reset all events that can be reset at this time. (Events that are PRESENT cannot be reset now.)Event Log Key (7) - Pressing the "EVENT LOG" key will navigate the display to the event log.RUN Key (8) - Pressing the "RUN" key will put the generator set into a mode where it will attempt to start the engine, except in cases where there are any active or present shutdown events.AUTO Key (9) - Pressing the "AUTO" key will cause the engine to enter the "AUTO" mode. The engine will start if the module receives a start command from a remote-start source.STOP Key (10) - Pressing the "STOP" key will put the generator set into a mode where it will stop the engine. Depending on configuration, the set may run on for a cooldown period before stopping the engine.Escape Key (11) - The "ESCAPE" key is used to navigate through the menus. When the key is pressed, the user moves backward or the user moves upward through the menus. The "ESCAPE" key is also used to exit out of entering data when the user is programming the setpoints. If the "ESCAPE" key is pressed while the user is programming the setpoints, changes made on the screen will not be saved to memory.Up Key (12) - The