PIN 7X5484 - Caterpillar

Introduction
This publication contains the information in order to install a magnet on the door on the AccuGrade CD700 display.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs. A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly. Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The warnings in this publication and the warnings on the product are not all inclusive. If a tool, a procedure, a work method, or an operating technique that is not specifically recommended by Caterpillar is used, you must be satisfied of your safety and the safety of other people. You should also make sure that the product will not become damaged or unsafe by the operation, the lubrication, the maintenance, or repair procedures that are chosen by you.Required Parts
Table 1
Required Parts    
337-5123     Magnet Kit    
Table 2
Contents of the 337-5123 Magnet Kit    
Quantity     Description    
1     Adhesive    
10     Magnet    
10     Alcohol Pad    Installation Procedure
Illustration 1 g01769713
(1) Bosses (2) Location of Magnet
Clean the area on the door for the location of the magnet (2). Use the alcohol pad to clean the area. Then, allow the area to air dry.Refer to Illustration 1.
Illustration 2 g01769862
Apply the adhesive to one side of the magnet and install the magnet (3) between the two bosses.Refer to Illustration 2.
Allow the adhesive to dry for approximately five minutes prior to shutting the door.