PIN AS 8E0175 - Caterpillar

8E0175 PIN AS Caterpillar parts 517, 527, D4HTSK II, D4HTSK III, D5HTSK II

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA8E0175
8E-0175
8E0175

Weight: 13 pounds 5 kg.

Information:

PIN LENGTH 217 mm

PIN OUTER DIAMERTER 63.48 mm

PIN PART NUMBER 8E0178

PLATE PART NUMBER 8E0186

LUBE OUTLET Y

MAX. THREAD SIZE 1.00-14

PIN END TYPE LEAD TAPER

PIN TRANSV HOLE N

PLATE FIXING HOLES Y

Buy PIN AS 8E0175 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK SKIDDER,

Compatible equipment models: 8E0175:

TRACK SKIDDER 517 527 D4HTSK II D4HTSK III D5HTSK II Caterpillar

Number on catalog scheme: 12

For full view, you need register

Information:

Illustration 1 g01737635
Schematic for the Lift Relays
This diagnostic code is associated with the Lift Relays. The FMI 6 means that the ECM has determined that the current of the relay circuit is above normal.The possible causes of the diagnostic code are listed:
The energize circuit of the relay is shorted to ground.
A wire of the controller harness is shorted to ground.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of SPN 5013 FMI 6 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The machine response is listed:
The Lift Relays may not turn ON.
Machine performance may not lift material properly if material is lifted at all.Note: Before performing this procedure, verify that all circuit breakers and fuses in the charging circuit and the ECM system supply circuit are closed. If a problem with a circuit breaker or a fuse is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Test Step 1. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Turn the disconnect switch and the key start switch to the OFF position.
Inspect the harness connectors. Clean the contacts of the harness connectors and check the wires for damage to the insulation that is caused by excessive heat, corrosion, or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit.
Use the Caterpillar Electronic Technician (ET) service tool, if available, in order to perform a “Wiggle Test” on the machine wiring harness. The wiggle test can detect intermittent shorts or opens in the machine wiring harness.
Reconnect all harness connectors. Make sure that the connectors are fully seated and the clips for each connector are completely fastened.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the SPN 5013 FMI 6 diagnostic code is still active. Expected Result:The SPN 5013 FMI 6 diagnostic code is still active.Results:
YES - The SPN 5013 FMI 6 diagnostic code remains active. Proceed