PIN-CONNECTOR 8N1542 - Caterpillar

Fabricate the three brackets per the dimensions given in Illustration 1, Illustration 2, and Illustration 3.
Illustration 4 g06124016
(AM) 25.4 0.5 mm (1.00 0.02 inch)
(AN) 15.4 0.25 mm (0.61 0.010 inch)
(AP) Diameter is 14 mm (0.6 inch)
(AR) Diameter is 36 mm (1.4 inch)
(AS) 12 mm (0.5 inch)
(AT) 44 mm (1.7 inch)
(AU) 44 mm (1.7 inch)
(AV) 7 mm (0.3 inch)
(AX) 11 mm (0.4 inch)
(AY) Diameter is 2 X 10.5 mm (0.41 inch)
(AZ) Diameter is 125 mm (4.9 inch)
Fabricate the special jig per the dimensions given in the Illustration 4.
Illustration 5 g06124021
(BB) 6Y-6613 Idler Shaft
(BC) Washer
(BD) O-ring
(BE) Bolt
Locate the upper 6Y-6613 Idler Shaft (BB) on the rear pump drive, remove washer (BC), o-ring (BD), bolt (BE) and save the parts, as shown in Illustration 5.Note: Do not rotate the idler shaft while removing the bolt.Thread an "M10" threaded locating pin (BF) into the shaft puller hole. The pin should protrude from shaft surface not more than 10 mm (0.4 inch)
Illustration 6 g06124022
(BE) Bolt
(BF) Locating Dowel
Locate the jig on the pin using locating dowel (BF) and reuse the idler bolt (BE) without washer (BC), tighten the jig to the shaft to a specified torque of 100 20