PIN 9J0834 - Caterpillar

9J0834 PIN Caterpillar parts 920, 926, 930, 930R

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA9J0834
9J-0834
9J0834

Weight: 0.03 pounds 0 kg.

Information:

OVERALL LENGTH 55.88 mm

OUTSIDE PIN DIAMETER 6.121 mm

END TYPE A CHAMFER

END TYPE B CHAMFER

FLAT/VENTED N

INSIDE DIAMETER 0

Buy PIN 9J0834 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL LOADER,

Compatible equipment models: 9J0834:

WHEEL LOADER 920 926 930 930R Caterpillar

Number on catalog scheme: 24

For full view, you need register

Information:

The possible conditions that can cause this diagnostic code are listed below:
A hydraulic problem is causing above normal hydraulic pump pressure.
Both pressure sensors are installed and do not agree with each other.
The sensor has failed.
The signal circuit for the sensor is shorted to a voltage source.
The ECM has failed. This condition is unlikely.Check that a diagnostic code CID 0262 for the 5V sensor supply is not active before performing this procedure. If an active CID 0262 diagnostic code is present, correct the problem and clear the diagnostic code before performing this procedure.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Test Step 1. CHECK THE HYDRAULIC PUMP DISCHARGE PRESSURENote: This test step requires the installation of a pressure gauge at the tap for the outlet pressure for the main hydraulic pump.
After a pressure gauge is installed at the main hydraulic pump pressure tap, start the engine and run the engine at low idle.
Ensure that all the following conditions are in place before proceeding to the next step:
Disable the steering system by not aligning the joystick to the angle of the front wheels.
Disable the steering system by not having the operator in the operator seat.
Move the implement lockout switch to the LOCK position.
Use the Caterpillar Electronic Technician (Cat ET) in order to check the status of the main hydraulic pump pressure.
Observe the display of the pressure reading that is on the Cat ET status screen. Note the reading on the pressure gauge from the pump outlet. Compare the two sets of readings. Expected Result:The pressure is observed on the Cat ET status screen and the pressure that is observed on the pressure gauge are approximately the same. However, the pressure reading is above the 7500 kPa (1089 psi) standby pressure limit.Results:
YES - The pressure observed on the status screen and the value