PIN 9L9378 - Caterpillar

Rated Power
This parameter specifies the rated power of the engine.Rated Peak Torque
This parameter specifies the rated peak torque of the engine.Top Engine Speed Range
This parameter specifies the maximum speed setting for the engine.Test Spec
This is the engine's "Test Specifiction Number". Use this number to retrieve data that is related to the engine's specifications from the Technical Marketing Information System (TMI). The following information can be retrieved from TMI:
"As shipped consists"
"Engine test specifications"
"Systems data"
"Physical data"
"Gasket kit data"
"Reman parts"
"Performance data"A link to TMI Web can be found on the web site for the Service Information System (SIS).Total Tattletale
The total tattletale counts the number of changes to system parameters.Ether Solenoid Configuration
This parameter is enabled in order to define the installation status of an ether starting aid for the engine.Engine Retarder Enable Command (Option)
This parameter is enabled in order to define the installation status of compression brakes for the engine.Parameter Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
Configuration Group 1
Equipment ID 17 alphanumeric characters Blank None
ECM Identification Parameters
Engine Serial Number 0XX00000 or XXX00000 Blank Factory
ECM Serial Number Hardware Dependent Blank Read Only(1)
ECM Part Number Hardware Dependent Blank Read Only(1)
Software Group Part Number Software Dependent Read Only(1)
Software Group Release Date Software Dependent Read Only(1)
Software Group Description Software Dependent Read Only(1)
System Parameters
FLS Programmed at the Factory Factory
FTS Programmed at the Factory Factory
Rated Power Software Dependent Read Only(1)
Rated Peak Torque Software Dependent Read Only(1)
Top Engine Speed Range Software Dependent Read Only(1)
Test Spec Software Dependent Read Only(1)
Total Tattletale 0 to 65535 0 Read Only(1)
Engine Configuration Parameters
Ether Solenoid Configuration Not Installed
Continuous Flow Solenoid Continuous Flow Solenoid None
Engine Fan Control On
Off Off None
Engine Retarder Enable Command (Option) Enabled
Disabled Disabled None
(1) This parameter can be viewed only. No changes are allowed.Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
Equipment ID
Engine Serial Number
ECM Serial Number
ECM Part Number
Software Group Part Number
Software Group Release Date
Total Tattletale
FLS
FTS
Ether Solenoid Configuration
Engine Fan Control
Engine Retarder Enable Command
Table 3
Information From Engine Information Plate
Engine Serial Number
FLS
FTS
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Use of incorrect parameters could cause damage to the engine. Use of the incorrect parameters may also void the Caterpillar warranty or the emission certification for the engine.