PIN AS 9R5925 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 439-3939 Link Bracket 4
6V-3532 Bolt 4 Start By:
Connect the steering frame lock.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Illustration 1 g03346608
Disconnect harness assemblies (1). Disconnect harness clip (2) from the cab.
Illustration 2 g03346610
Disconnect harness assemblies (3). Disconnect harness clip (4) from the cab.
Illustration 3 g03346618
Disconnect harness assemblies (5) and harness assembly (6). Cut the cable strap and disconnect cable assembly (7). Disconnect harness clips (8) from the cab.
Illustration 4 g03346622
Disconnect ground straps (9) from the cab.
Illustration 5 g03346626
Remove nuts (10) to lower brake valve (11).
Illustration 6 g03346630
Disconnect hose assemblies (12).
Illustration 7 g03346632
Disconnect hoses (13).
Illustration 8 g03346635
Close valve (14). Disconnect hoses (15).
Illustration 9 g03346736
Remove bolts (16).
Illustration 10 g03349992
Illustration 11 g03346776
Typical Example
Attach Tooling (A) and a suitable lifting device to cab (17). The weight of cab (17) is approximately 1270 kg (2800 lb).
Remove bolts (18). Use Tooling (A) and the suitable lifting device to remove cab (17).Installation Procedure
Install cab (17) in the reverse order of removal.