PIN 9R7696 - Caterpillar

Use this procedure to troubleshoot the electrical system if a problem is suspected with the sensors or if any one of the diagnostic codes in Table 1 is active or easily repeated.
Table 1
Diagnostic Codes Table    
Code and Description    Conditions which Generate this Code    System Response    
94-3 Fuel Delivery Pressure Sensor voltage above normal     The Electronic Control Module (ECM) detects signal voltage that is above normal for 8 seconds.     The code is logged.
The value of the parameter is set to a gauge pressure of
600 kPa (87 psi).    
94-4 Fuel Delivery Pressure Sensor voltage below normal     The ECM detects signal voltage that is below normal for 8 seconds.    
100-3 Engine Oil Pressure Sensor voltage above normal     The ECM detects signal voltage that is above normal for 8 seconds.     The code is logged.
The value of the parameter is set to a gauge pressure of
600 kPa (87 psi).    
100-4 Engine Oil Pressure Sensor voltage below normal     The ECM detects signal voltage that is below normal for eight second.    
100-10 Engine Oil Pressure Sensor abnormal rate of change     The signal voltage has not changed at a normal rate for 30 seconds.
Engine speed must be above 600 rpm.    
127-3 Transmission Oil Pressure Sensor voltage above normal     The ECM detects signal voltage that is above normal.     The code is logged.    
127-4 Transmission Oil Pressure Sensor voltage below normal     The ECM detects signal voltage that is below normal.    
177-3 Transmission Oil Temperature Sensor voltage above normal     The ECM detects signal voltage that is above normal.     The code is logged.    
177-4 Transmission Oil Temperature Sensor voltage below normal     The ECM detects signal voltage that is below normal.    
1785-3 Intake Manifold Pressure Sensor voltage above normal     The ECM detects signal voltage that is above normal for 2 seconds.     The code is logged.
The value of the parameter is set to a gauge pressure of
100 kPa (15 psi).    
1785-4 Intake Manifold Pressure Sensor voltage below normal     The ECM detects signal voltage that is below normal for 2 seconds.    
1785-10 Intake Manifold Pressure Sensor abnormal rate of change     The signal voltage has not changed at a normal rate for 30 seconds.
Engine speed must be above 1000 rpm.    System OperationUse this procedure to troubleshoot any suspect problems with the following sensors:
Fuel pressure sensor
Engine oil pressure sensor
Transmission oil pressure sensor
Transmission oil temperature sensor
Intake manifold pressure sensor
Coolant level sensor
Exhaust temperature sensorThe supply voltage is routed to terminal A of each sensor connector. The sensor return is routed to terminal B of each sensor connector. The sensor signal is routed to terminal C of each sensor connector. The ECM provides short circuit protection for the internal power supply. A short circuit to the battery will not damage the internal power supply.The ECM performs an automatic calibration of these sensors whenever the ECM is powered and the engine is off for at least