PIN AS 9V9542 - Caterpillar

you perform any operation or any maintenance procedure.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.The normal oil change interval is Every 500 Service Hours or Three Months. If the engine is operated under severe conditions or if the oil is not Caterpillar oil, change the oil after Every 250 Service Hours or after One Month. Severe conditions include the following factors: high temperatures, continuous high loads and extremely dusty conditions .Refer to the results of the S O S oil analysis in order to determine if the oil change interval should be decreased to 250 hours. Consult your Caterpillar Dealer for detailed information regarding the optimum oil change interval.When Required
Battery - Recycle
Battery Electrolyte Level - Check
Battery, Battery Cable or Battery Disconnect Switch - Replace
Bucket Cutting Edges - Inspect/Replace
Bucket Tips - Inspect/Replace
Bucket Wear Plates - Inspect/Replace
Circuit Breakers and Fuses - Reset/Replace
Engine Air Filter Primary Element - Clean/Replace
Engine Air Filter Secondary Element - Replace
Engine Air Filter Service Indicator - Inspect
Fuel System Priming Pump - Operate
Fuel Tank Water and Sediment - Drain
Oil Filter - Inspect
Radiator Core - Clean
Window Washer Reservoir - Fill
Window Wiper - Inspect/Replace
Window Wiper - Inspect/Replace
Every 10 Service Hours or Daily
Backup Alarm - Test
Cab Air Filter - Clean/Replace
Cooling System Level - Check
Engine Oil Level - Check
Fuel System Water Separator - Drain
Hydraulic System Oil Level - Check
Seat Belt - Inspect
Tire Inflation - Check
Walk-Around Inspection
Windows - Clean
Every 50 Service Hours or Monthly
Attachment Arm and Cylinder Linkage - Lubricate
Every 100 Service Hours or 2 Weeks
Articulation Bearings - Lubricate
Axle Oscillation Bearings - Lubricate
Steering Cylinder Bearings - Lubricate
Every 250 Service Hours or Monthly
Air Conditioner - Test
Battery - Inspect
Braking System - Test
Cooling System Coolant Additive (DEAC) - Add
Differential and Final Drive Oil Level - Check
Drive Shaft Universal Joints - Lubricate
Hydrostatic Drive Oil Level - Check
V-Belts - Inspect/Adjust/Replace
Every 500 Service Hours or 3 Months
Engine Oil and Filter - Change
Fuel System Primary Filter - Replace
Fuel System Water Separator Element - Replace
Fuel Tank Cap - Clean
Hydraulic System Oil Filter - Replace
Every 1000 Service Hours or 6 Months
Hydraulic System Oil - Change
Rollover Protective Structure (ROPS) - Inspect
Every 1000 Service Hours or 1 Year
Engine Valve Lash - Check
Every 2000 Service Hours or 1 Year
Brake Discs - Check
Differential and Final Drive Oil - Change
Engine Crankcase Breather - Clean
Fuel Injection Timing - Check
Hydrostatic Drive Oil - Change
Every 3000 Service Hours or 2 Years
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Clean/Replace
Every 6000 Service Hours or 4 Years
Cooling System Coolant (ELC) - Change