PINION AS 3087793 - Caterpillar

Illustration 1 g06024041
Right Console
(1) Display
(2) Increase switch
(3) Decrease switch
(4) Keypad
(5) Mode switch
(6) Propel leverThe operator controls are on the right console.Display (1) informs the operator of basic operational information and system faults. When the operator selects an operational mode, the display shows a pop-up message that identifies the selected mode. The operational modes include off, manual mode, and automatic mode. Also, both actual and setpoint target pressures for the tires or contact pressure is displayed.Increase switch (2) and decrease switch (3) are mounted on propel lever (6). The switches are momentary contact buttons. The switch signals are sent to the options ECM. A single press of less than 2 seconds increases the tire pressure by 7 kPa (1 psi). Press-and-hold operation of either switch for longer than 2 seconds scrolls the pressure value at a rate of 70 kPa/sec (10 psi/sec).Keypad (4) contains mode switch (5) for the air-on-the-run system. This momentary switch cycles the system between
off
manual
automaticmodes with each press. The mode switch signal is sent to the options ECM.