PINION 3724123 - Caterpillar

Illustration 36 g03583457
(7) 5P-1471 Hose (8) 5P-4325 Clip (9) 8T-4136 Bolt (10) 8T-4121 Hard Washer (11) 5P-0597 Hose Clamp
Install hose (7) of 1030 mm (40.5 inch) per dust ejection hoses to the pre-cleaner (R) using two hose clamps (11). Secure hoses (7) using four clips (8), four bolts (9), and four hard washers (10) .
Illustration 37 g03583477
(7) 5P-1471 Hose (11) 5P-0597 Hose Clamp
Secure dust ejection hose (7) to the muffler assemblies using two hose clamps (11) .
Illustration 38 g03583478
(12) 193-3973 Cable Strap
Illustration 39 g03583479
(12) 193-3973 Cable Strap
Install back the under hood service lights (K), switches (L), and wiring harnesses (M) that were saved in Step 11. Secure wiring harnesses (M) using 11 cable straps (12) .
Illustration 40 g03583480
Install back two rubber latches (G) using two locking pins (J) and two clevis pins (H) that were saved in Step 5.
Illustration 41 g03583482
(1) 440-5168 Hood As
Turn over new hood assembly (1). Bottom of hood must be at least 350 mm (13.8 inch) from the ground.
Illustration 42 g03583483
(13) 440-1969 Cover (14) 440-1970 Cover (15) 8T-4195 Bolt (10) 8T-4121 Hard Washer
Install cover (13) and cover (14) over the muffler assemblies and secure using ten bolts (15) and ten hard washers (10) .
Illustration 43 g03583485
(16) 219-9914 Ejector (17) 388-7019 Bent Bolt Clamp
Install two ejectors (16) using two bent bolt clamps (17) .
Illustration 44 g03583486
(18) 242-9536 Heat Shield As (19) 2P-7418 Clamp (20) 0S-1590 Bolt (21) 5M-2894 Hard Washer (22) 2N-2766 Locknut
Install two heat shield assembly (18) using two clamps (19), two bolts (20), two hard washers (21), and two locknuts (22) .
Illustration 45 g03583487
(23) 7S-4411 Rain Cap As
Install two rain cap assemblies (23) .
Illustration 46 g03583488
Install two prescreener assemblies (C) using two clamps (D) that were saved in Step 2.
Use suitable lifting device to install the new hood assembly (1). Refer to Disassembly and Assembly, RENR7544, "Hood - Install" for installing hood assembly on D10T machines.