PIPE 0856307 - Caterpillar

Illustration 2 g06060912
369-5295 Stick Lines Gp
Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. Plugging hoses and tubes helps to prevent fluid loss, and helps to keep contaminants from entering the system.
Illustration 3 g03682576
(2) 294-6467 Tube As
(3) 356-8021 Hose As
(6) 442-0234 Ball Valve
(8) 453-2836 Bolt
(10) 1P-3705 Rectangular Seal
(13) 306-1355 Half Clamp
(14) 5P-8077 Half Flange
(15) 453-2840 Bolt
(17) 8T-4121 Hard Washer
(18) 447-1707 Bolt
(20) 447-1711 Bolt
(24) 451-2175 Hard Washer
Install stick lines group onto the right side of the stick.
Illustration 4 g06060913
(1) 187-9915 Tube As
(4) 356-8084 Hose As
(5) 389-2407 Manual Valve Gp
(8) 453-2836 Bolt
(9) 1P-3704 Rectangular Seal
(11) 1P-5767 Half Flange
(12) 306-1354 Half Clamp
(15) 453-2840 Bolt
(16) 7X-0584 Hard Washer
(17) 8T-4121 Hard Washer
(19) 8T-4183 Bolt
(21) 8T-4194 Bolt
(22) 8T-4223 Hard Washer
(24) 451-2175 Hard Washer
Install stick lines group onto the left side of the stick.
Tighten all hardware and fitting to proper torque unless otherwise specified. Refer to Specifications, SENR3130, "Torque Specifications".
Illustration 5 g00687600
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue, causing serious injury, and possible death.Always use a board or cardboard when checking for a leak.Do not check for pin hole leaks in pump or motor hoses during a steer stall condition. If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury immediately.
Inspect the fittings for hydraulic leaks.