1455872 PIPE AS Caterpillar parts
312B L, 312C, 315B L
Rating:
Alternative (cross code) number:
CA1455872
145-5872
1455872
CA1455872
145-5872
1455872
Weight: 2 pounds 0 kg.
EXCAVATOR,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$14.99
26 Dec 2019
-: -
O'Cedar Scrub Fresh Toilet Bowl System Refill
To be used exclusively with Scrub Fresh Hygienic toilet brush and caddy - #1455872 || Hygienic spray freshens brush after each use || 1.5 oz. lasts approximately 3 months
To be used exclusively with Scrub Fresh Hygienic toilet brush and caddy - #1455872 || Hygienic spray freshens brush after each use || 1.5 oz. lasts approximately 3 months
Number on catalog scheme:
11
For full view, you need register
Information:
Illustration 1 g02584936
Connections of the Reverse Solenoid Clutch 1This diagnostic code is associated with the Reverse Solenoid Clutch 1. The FMI 05 means that the ECM has detected that the current for the solenoid circuit is below normal.Conditions that cause this diagnostic code to be activated are:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. The failure of the ECM is unlikely. Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. System Response:Reverse gear will be disabled.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected.Test Step 1. CHECK THE SOLENOID
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire 751-GN) to contact 2 (wire J808-BK).
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the CID 1401 FMI 05 diagnostic code.Expected Result:The CID 1401 FMI 05 diagnostic code is no longer active. A CID 1401 FMI 06 diagnostic code becomes active when the jumper wire is connected.Results:
YES - The CID 1401 FMI 05 diagnostic code is no longer active. A CID 1401 FMI 06 diagnostic code becomes active when the jumper wire is connected. The solenoid has failed.Repair: Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOP
NO - The CID 1401 FMI 05 diagnostic code remains active. The jumper wire does not affect the status of the active diagnostic code. The solenoid is not causing the problem. Proceed to Test Step 2.Test Step 2. CHECK THE CIRCUIT FOR AN OPENThe jumper wire that was installed in the previous Test Step remains in place.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness ECM connector J1 from the ECM.
At the machine harness connector J1 for the ECM, measure the resistance from contact J1-65 (wire 751-GN) to contact J1-55 (wire J808-BK).
While observing the multimeter resistance measurement, wiggle the machine harness connectors for the ECM and wiggle the machine harness connector for the solenoid. Gently pull on the wires and move the wires around.Expected Result:The resistance measurement is less than 5.0 ohms at all times during the manipulation of the harness and connectors.Results:
OK - The resistance measurement is less
Caterpillar parts catalog:
Parts pipe Caterpillar catalog:
3054, 3054B, 307, 312, 312B L, 312C, 315, 315B L, 317, 416B, 416C, 416D, 420D, 424D, 426C, 428B, 428C, 428D, 430D, 432D, 436C, 438C, 438D, 442D, 554, 908, 914G, AP-800C, BG-225B, BG-225C, CB-434B, CB-...
1604828
PIPE
3054, 3054B, 312B L, 312C, 315B L, 908, M312, M315
3054, 3054B, 312B L, 312C, 315B L, 908, M312, M315
120B, 12F, 312, 312B L, 312C, 315, 315C, 317, 3208, CS-323C
307, 307B, 307C, 308C, 311, 311B, 311C, 312, 312B, 312B L, 312C, 312C L, 313B, 314C, 315, 315B, 315B FM L, 315B L, 315C, 317, 317B LN, 318B, 318C, 319C, 320 L, 320B, 320B FM LL, 320B U, 320C, 320C FM,...
7I7762
PIPE-GAUGE
311, 311B, 312, 312B, 312B L, 315, 315B, 315B L, 317, 317B LN, 318B
311, 311B, 312, 312B, 312B L, 315, 315B, 315B L, 317, 317B LN, 318B
1396000
PIPE AS
312, 312B L, 312C
312, 312B L, 312C
1450182
PIPE AS
312B L, 312C
312B L, 312C
1450184
PIPE AS
312B L, 312C
312B L, 312C
1450185
PIPE AS
312B L, 312C
312B L, 312C
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2470C, 2491, 2570C, 2590, 2670C, 303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304, 304.5, 304C CR, 304D CR, 304E, 305, 305.5, 305.5D, 305.5E,...
1489903
PIPE AS
315B L
315B L
1797603
PIPE AS
311C, 311D LRR, 312C, 312C L, 312D, 312D L, 312E, 312E L, 314C, 314D CR, 314D LCR, 315C
311C, 311D LRR, 312C, 312C L, 312D, 312D L, 312E, 312E L, 314C, 314D CR, 314D LCR, 315C
1547950
PIPE AS
312B L
312B L
1807840
PIPE
M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C, M325C MH
M312, M313C, M315, M315C, M316C, M318, M318C, M318C MH, M320, M322C, M325C MH
1362525
PIPE AS
307
307
1362526
PIPE AS
307
307
1362524
PIPE AS
307
307
1362523
PIPE AS
307
307
1427206
PIPE AS
312B L
312B L
1449232
PIPE AS
311B, 312B, 312B L, 315B L, 317B LN, 318B
311B, 312B, 312B L, 315B L, 317B LN, 318B
1219058
PIPE
312B L
312B L
1391639
PIPE AS
311B, 312B, 312B L
311B, 312B, 312B L
1293348
PIPE AS
311B, 312B, 312B L, 314C, 314D CR, 314D LCR, 315B L, 317B LN, 318B, 320B, 320B FM LL, 320C, 320D LRR, 320D RR, 322B L, 322B LN, 325B, 325B L, 330B L, M325B, W330B
311B, 312B, 312B L, 314C, 314D CR, 314D LCR, 315B L, 317B LN, 318B, 320B, 320B FM LL, 320C, 320D LRR, 320D RR, 322B L, 322B LN, 325B, 325B L, 330B L, M325B, W330B
1449292
PIPE
312B L, 312C, 315B L
312B L, 312C, 315B L