PIPE 3997626 - Caterpillar

Normal Mode
The AccuGrade System automatically operates in Normal mode when you start up the Display. In order to do this, turn on the machine's ignition. Press the "POWER" key.By default, the following softkeys are available when the Display is in Normal Mode.
Select or create a design file ("Select Design<name>")
Select blade tip focus ("Blade:Left or Blade: Right")
Select alignments for guidance ("Alignment<name>")
Set the horizontal offsets ("H. Offset:")
Set the vertical offsets ("V. Offset:")
Turn map recording on or off (if enabled)
Set the Vertical Guidance
Zoom and pan
Set the GPS Accuracy
Zoom and panYou can also use the "Setup Menu – Configuration" dialog to perform the following when you are in Normal mode.
Edit the blade wear value
Set the vertical offset switch increment (automatic controls systems)
Set the light bar scales and on-grade tolerance
Select and reset map recording
Set the valve speed
Restore Display settings or machine settings
View basic diagnostic informationRefer to the Operation and Mainteance Manual, SEBU8006 for more details on Normal mode operation.Service Mode
If you lack experience with the AccuGrade System, use extreme care when you are in Service Mode so that you do not accidentally change the AccuGrade System settings.
Service Mode allows you to have access to all available options that the AccuGrade System offers.Use Service Mode in order to change the settings that affect the operation of the AccuGrade System.In order to turn on Service Mode, turn off the Display if the Display is ON. Press and hold down the "OK" key as you press the "POWER" key. Make sure that you hold down the "OK" key until the Display shows