PIPE GP-EXHAUST 4N8737 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 8T-2998 Lubricant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00572214
Do not use a torch to heat camshaft gear (7). Raise the temperature of camshaft gear (7). Note: The key for camshaft gear (7) must be in position on the camshaft before camshaft gear (7) is installed.
Apply Tooling (B) to the camshaft lobes and the rollers for the valve lifter. Apply clean engine oil to the bearing journals of the camshaft.
Illustration 2 g00572105
Install camshaft (6) until the rear of the camshaft is even with the rear of the cylinder block.
Illustration 3 g00572090
Align Marks “V” on the camshaft gear and the idler gear.
Illustration 4 g00572095
Install plate (4) and bolts (5) on the cylinder block.
Illustration 5 g00572086
Install gear (3), plate (2), and bolts (1) on the rear of the camshaft. End By:
Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Install the lifter group. Refer to Disassembly and Assembly, "Lifter Group - Remove and Install".
Install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install".