PIPE-INLET 6N0316 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Description Part Number Qty
A 6V-6146 Load Leveler Gp 1
189-0412 Clevis 1
189-0863 Shackle As 2
B 366-6003 Handler As 1 Start By:
Remove the crankcase guard.
Remove the power train guard.
Remove the rear drive shaft.
Remove the rear compactor wheels.
Illustration 1 g03693885
Disconnect tube assembly (1) from rear trunnion support (2).
Illustration 2 g03693887
Disconnect tube assembly (3) from front trunnion support (4).
Illustration 3 g03688740
Illustration 4 g03688747
Attach Tooling (A) and a suitable lifting device to oscillating axle (5). The weight of oscillating axle (5) is approximately 2013 kg (4440 lb).
Illustration 5 g03688759
Remove nuts (6) and the spacers. Repeat this step for the opposite side.
Illustration 6 g03688762
Remove nuts (7) and the spacers. Repeat this step for the opposite side.
Illustration 7 g03688747
Illustration 8 g03688763
Typical Example
Use Tooling (A) and the suitable lifting device to lower oscillating axle (5) onto Tooling (B). Remove the suitable lifting device from oscillating axle (5). Use Tooling (B) to move oscillating axle (5) from under the machine.Installation Procedure
Install oscillating axle (5) in the reverse order of removal.
Tighten nuts (6) and (7) to a torque of 450 50 N m (332 37 lb ft). Tighten nuts (6) and (7) an additional 120 ° 10°.