PIPE 7I9029 - Caterpillar

Personal Protection/Important Information
Illustration 3 g02166423
Personal Protection/Important InformationHazard Avoidance
Crushing Hazard (foot)
Crushing Hazard (hand)
Pinch Point General Information Section
Illustration 4 g03878700
Introduction
The 469-7606 Lifting Bracket Assembly is a cylinder shaped lifting device used to provide a safe method for removing and installing the 197-0960 Brake Hub. It is used with a hoist or other suitable lifting device. References
For more information on using the 469-7606 Lifting Bracket Assembly, refer to the appropriate Disassembly and Assembly Manual.Additional Contact Information
For additional product support questions concerning this tool, contact the Dealer Service Tools Hotline at:USA: 800-542-8665, Option 1International: 1-309-578-7372Note: Continuing improvement and advancement of product design can mean some photographs or illustrations in this publication will show details that are different from your service tool.Nomenclature
Illustration 5 g03883736
Table 1
469-7606 Brake Hub Lifting Device    
Working Load Limit (WLL)     109 kg (240 lb)    
Weight     4.3 kg (9.5 lb)    
Dimensions (mm)     705 Ø x 147    
Table 2
Serviceable Parts List    
Qty     Part No     Name    
1     469-7606     Brake Hub Lifting Device    
2     4L-6454     Bolt 3/8 - 16    
2     5C-6565     Bolt 1/2 - 13    
2     6V-8801     Nut 3/8 - 16    
2     439-3940     Link Bracket Assembly    Do not exceed Working Load Limit (WLL) of 109 kg (240 lb).Operation Section
The 469-7606 Brake Hub Lifting Device is used to lift the 197-0960 Brake Hub.Note: It is very important to keep the bracket assembly level while lifting to avoid tipping. The lifting point holes will allow for balancing the load.Attach 467-7605 Brake Hub Lifting Device to the 197-0960 Brake Hub. Use 4L-6454 Bolt, 5C-6565 Bolt, and 6V-8801 Nut to secure the bracket assembly to the brake hub. Use an appropriate chain and shackle to lift the brake hub. Do not use the lifting device without a suitable shackle.Note: Refer to the appropriate Disassembly and Assembly Service Manual for the correct location of lifting point.Maintenance Section
Inspection
If components are worn or damaged, they must be replaced.
Inspect lifting bracket assembly and all related hardware before each use. Immediately replace any worn or damaged components.
Inspect all welds and check for damaged, cracked, or bent components.
Illustration 6 g02701196
Inspect all hardware for damaged threads and cracked, or bent components.
Do not use unless all load identification markings are legible.
Do not use if shackle holes or bolt holes are elongated.
Have tools inspected annually by an approved dealership inspector. Maintain a written record of all inspections according to all local occupational safety regulations.Cleaning
Clean the tooling using a non-solvent based cleaner.Storage
Store indoors in a clean, dry location to prevent rust or corrosion. Tooling can be damaged by moisture or high humidity. The tool should be stored in the most stable position.Tool Disposal
At the end of the operational life of the tool, destroy the tool and dispose of as scrap.