PISTON 0848684 - Caterpillar

Illustration 1 g01521810
Machine ECM Location Code SchematicThis diagnostic code is recorded when the software location code for the Machine ECM does not match the hardware location codes.Note: The Machine ECM is located inside the Center Console mounted to the access door.The probable cause of this diagnostic code is software. The wrong software has been flashed into the ECM.Note: Do not change the hard wired location code if you have flashed the incorrect software into the control.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.System Response:The machine is inoperable.The following pop-up message shows on graphical display: "Machine will not function until the fault has been fixed."Test Step 1. VERIFY HARDWARE AND SOFTWARE PART NUMBERS
Verify whether the part number of the software for the ECM is correct.Expected Result:Consult the Business Unit that is producing the product for the correct configuration for the machine.Results:
OK - All part numbers are correct for the ECM. Proceed to test step 2.
NOT OK - All part numbers are NOT correct. The installed ECM has the wrong part number or incorrect configuration software is installed.Repair: Replace the ECM with a module that has the correct part number or flash the correct configuration software. See Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program".STOPTest Step 2. VERIFY WHETHER THE LOCATION CODE MATCHES THE ET STATUS SCREEN.
Check the ET status screen in order to verify the location code .Expected Result:The location codes in the ET are correct.Results:
OK - The location codes in the ET are correct. Proceed to test step 3.
NOT OK - The location codes are NOT correct. Repair: Repeat this test step in order to verify that the software and hardware part numbers are correct. Proceed to test step 3 if the part numbers are correct.Test Step 3. INSPECT HARNESS CONNECTIONS
Turn