PISTON & ROD GP 1350779 - Caterpillar

Always inspect the primary element before and after cleaning with a light bulb inside the element. Discard the element, if any tears, rips or damage are evident.
2 Clean the inside of the air cleaner housing and the cover. Install a clean element and the cover. 3 Tighten the cover screws finger tight. Do not use a tool to tighten them. The primary element should be replaced or cleaned whenever the indicator is in the red zone.If the indicator again locks in the RED position shortly after the installation of a primary element, which has been cleaned six times, change to another clean element.If the indicator again locks in the RED position, shortly after the installation of a clean primary element, change the secondary element.Replace the secondary element at the time the primary element is serviced for the third time.Secondary Element
1 Remove the cover and the primary element. 2 Remove the secondary element. Discard the secondary element. 3 Cover the air inlet opening. 4 Clean the entire air cleaner, including the cap, if necessary.5 Uncover the air inlet opening.
Always replace the secondary element. Do not attempt to reuse it by cleaning.
6 Install a new secondary element. Tighten the retainer screws finger tight. Do not use a tool to tighten them. 7 Install a clean primary element and the cover. 8 Tighten the cover screw finger tight. Do not use a tool to tighten them.Cleaning Air Cleaner Elements
We recommend no other cleaning than with compressed air. When using pressure air wear a protective face shield and protective clothing. The maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes.
Do not clean any elements by bumping or tapping.Do not use elements with damaged pleats, gaskets or seals.Have spare elements on hand to use while cleaning used elements.
Pressure Air - 205 kPa (30 psi) Maximum
1 Direct the air inside the element along the length of the pleats. 2 Direct the air outside the element along the length of the pleats. Direct the air inside the element along the length of the pleats. Inspect the element.Inspecting Element
1 Insert a light inside each clean and dry element and inspect. Discard the element if rips or tears are found. 2 Wrap and store all good elements in a clean, dry place.Cap - Inspect and clean
Inspect the rain cap and clean if necessary.Dust Valve - Inspection and Cleaning
Inspect the valve, clean so that the lips close together. Change if faulty.Windshield Wipers And Washer - If Equipped
Inspect Blades
1 Inspect the windshield wiper blades. Replace them if they are worn or damaged, or if streaking occurs.Fuses
Inspect - Change Fuses
1 The fuse panel is located inside the cab on the right side. 2 Inspect the fuses. Replace any fuse if the element is broken.
If it is necessary to replace fuses frequently, consult your Caterpillar dealer.
Fuel Tank
Drain Water and Sediment
Escaping fuel is flammable. Do not smoke while draining water and sediment from the fuel tank.
Open the fuel tank drain plug. Drain water and