PISTON & ROD GP 1777500 - Caterpillar

Illustration 21 g00826993
Position left side enclosure (21) on the machine so that the mounting holes are lined up. Install three bolts (20) .
Install two bolts (19) on the inside of left side enclosure (21) .
Install hose (22) and tighten the hose clamps. Close the access door on the left side of the machine.
Illustration 22 g00824384
Connect wiring harness connectors (18) and secure the wiring harnesses with tie straps.
Illustration 23 g00823987
Install left side step assembly (17A) with bolts (17) .
Illustration 24 g00823904
Connect three control rods (16) to the main control valve with bolts (16A) and locknuts. Tighten the locknuts to a torque of 15 3 N m (11 2 lb ft). Apply 1U-8801 Rust Preventive Oil to all rod ends, to pins, to locknuts, and to all exposed threads.
Illustration 25 g00823877
Connect hose assembly (15) at the refrigerant coupling assembly.Note: The refrigerant coupling assembly should prevent any leakage of refrigerant from the air conditioning system.
Illustration 26 g00823819
Push winch control lever (14) through the cab console and position the winch control lever so that the mounting holes are lined up. Install bolts (13) .
Illustration 27 g00823803
Connect two electrical connectors (12) to the underside of the winch control lever.
Illustration 28 g00823771
Position the hydraulic oil filter assembly on the mounting bracket. Install the spacers and four bolts (11). Connect wire assembly (10) .
Illustration 29 g00823767
Position both the hydraulic oil filter assembly and the bracket and install two hidden bolts (8). The hidden bolts require a 16 mm wrench for installation. Connect wire assembly (9) .
Illustration 30 g00826955
Illustration 31 g00823693
Position right side enclosure (5) on the machine so that the mounting holes line up. Install three bolts (3) .
Install two bolts (4) on the inside of right side enclosure (5) .
Connect hoses (7). Connect wire assemblies (6). Close the access door on the right side of the machine.
Illustration 32 g00823657
Illustration 33 g00823653
Position cover (2) on the rear of the machine. Install six bolts (1) on the right side of cover (2). Install three bolts (1) on the left side of cover (2) .