PISTON GROUP 1N3600 - Caterpillar

Removal Procedure
Reference: Special Instruction, "Visual Service Procedures - Colors and Symbols" , M0066576
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
The space between the body and the frame becomes a zero clearance area when the body is lowered. Failure to install the retaining cable can result in injury or death to personnel working in this area.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install the truck body retaining cables. Refer to Operation and Maintenance Manual, "Cable (Truck Body Retaining)".Release the system pressure. Refer to Operation and Maintenance Manual, "System Pressure Release".
Illustration 1 g06282177
Illustration 2 g06282186
Illustration 3 g06282624
Illustration 4 g06282633Installation Procedure
Install the gear pump and motor (rear axle lubrication) in the reverse order of removal.