PISTON 2669397 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8H-0663 Bearing Puller Gp 1
126-7175 Push-Puller 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01232114
Typical example
Note: The crankshaft gear (1) may be a slip fit on the crankshaft (3). If the crankshaft (3) is installed in the engine, use a suitable tool to ensure that the crankshaft gear (1) is not a slip fit before the crankshaft is removed from the engine.
If the crankshaft gear (1) is a slip fit on the crankshaft (3), use Tooling (A) to remove the crankshaft gear and proceed to Step 4.
If the crankshaft gear (1) is not a slip fit on the crankshaft (3), remove the crankshaft from the engine. Refer to this Disassembly and Assembly Manual, "Crankshaft - Remove".
Use Tooling (A) to remove the crankshaft gear (1) from the crankshaft (3).
Remove the key (2) from the crankshaft (3). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01232114
Typical example
Thoroughly clean the journal on the crankshaft (3) for the crankshaft gear (1) and the keyway slot for the key (2). Inspect the journal for the crankshaft gear (1), the keyway slot, and the key for wear or damage. If necessary, replace any damaged component.
Install the key (2) into the keyway slot in the crankshaft (3). Note: The crankshaft gear (1) may be a slip fit on the crankshaft (3).
Check if the crankshaft gear (1) is a slip fit on the crankshaft (3). If the crankshaft gear (1) is a slip fit on the crankshaft (3), proceed to Step 5. Note: Ensure that heat is applied to the crankshaft gear (1) only. Do not apply heat directly onto the crankshaft (3).Note: Ensure that suitable clothing is worn in order to handle the heated crankshaft gear.
If the crankshaft gear is not a slip fit on the crankshaft, heat the crankshaft gear in an oven to 200 °C (392 °F).
Ensure that the shoulder on the crankshaft gear (1) is installed toward the front of the crankshaft (3). Install the crankshaft gear (1) onto the crankshaft (3) and the key (2). End By:
If the crankshaft was removed from the engine, install the crankshaft (3) at an appropriate time. Refer to this Disassembly and Assembly Manual, "Crankshaft - Install".