PISTON GP 2W9042 - Caterpillar

Illustration 1 g01404405
Schematic of transmission solenoid 3
This diagnostic code is associated with transmission solenoid 3. The FMI 03 means that the Power Train/Chassis ECM has determined that the voltage of the solenoid coil circuit is above normal. The possible causes of the diagnostic code are:
The solenoid coil has failed.
The energize circuit of the solenoid coil is shorted to the +battery circuit.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1403 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the transmission fault alert indicator will flash. Also, the action lamp will flash and the action alarm will sound. The transmission will shift to NEUTRAL and the parking brake will apply after 5 seconds.Reference: For information on the limp home mode, refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Transmission Solenoid Fault".Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO THE +BATTERY CIRCUIT
Turn the key start switch and the battery disconnect switch to the OFF position.
Disconnect the machine harness connectors from the solenoid and the ECM.
At the machine harness connector for the ECM, measure the resistance from contact J1-49 (wire J837-BU(Blue)) to all contacts that are used in the machine harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5 ohms. Results:
YES - Each resistance measurement is greater than 5 ohms. The machine harness is correct. Proceed to Test Step 2.
NO - One or more resistance measurements are less than 5 ohms. There is a short in the machine harness. The short is between J1-49 (J837-BU(Blue)) and the circuit that has the low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the battery disconnect switch and the key start switch to the ON position.
Operate the machine.
Determine if the CID 1403 FMI 03 is active. Expected Result:The CID 1403 FMI 03 is active.Results:
YES - The CID 1403 FMI 03 is active. The problem has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Electronic Control Module (ECM) - Replace". STOP
NO - The CID 1403 FMI 03 is not active. The problem does not exist at this time.Repair: The initial diagnostic code was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.STOP