PISTON 2Y5789 - Caterpillar

Configuration
S/N: DXR350-UP The configuration is used in order to enable or set the available features. The configuration should be performed if the Power Train/Chassis Electronic Control Module (ECM) has been replaced or the ECM was removed. Perform all configurations that are applicable. The configurations are listed:
"Transmission Maximum Forward Gear"
"Body Up Gear Limit"
"Body Float Gear Limit"
"Hoist System Enable Status"
"Ejector System Enable Status"
"Hoist Lower Valve Adjustment Status"
"Desired Engine Retarder Speed"
"Machine Speed Limit"
"Machine Underground Speed Limit"
"Transmission Oil Pressure Sensor"
"Interlock System Engine Shutdown Enable Status"The Caterpillar Electronic Technician (ET) service tool is used in order to access the configuration procedures. For more information, refer to the manual that was provided with the ET.Accessing Configurations
Connect the ET to the machine. After communication has been established, the ET will list the electronic control modules that are on the machine. Choose the menu item Transmission. Select the drop-down menu that is called "Service". Then, select the "Configuration" function. The list of configurations will appear.
Illustration 1 g01878587
Typical exampleSelect the drop-down menu that is called "Service". Then, select the "Configuration" function. A list of items will appear. From the list, select the desired item from the list. A pop up box that is called "Change Parameter Value" will appear."Change Parameter Value"
Illustration 2 g01879541
Typical ET screen for the "Change Parameter Value"The values for the parameter status are listed below.
Table 1
Parameter Status    
Parameter     Status     Range    
"Transmission Maximum Forward Gear" (1)     4     4    
"Body Up Gear Limit"     1     1 to 3    
"Body Float Gear Limit"     1     1 to 3    
"Hoist System Enable Status"     "Enabled"     "Enabled" or "Not Installed"    
Ejector System Enable Status     "Not installed"     "Installed or Not Installed"    
Hoist Lower Valve Adjustment Status     0     -5° and +5°    
Desired Engine Retarder Speed     2300     2160 to 2330    
"Machine Speed Limit"    
52 km/h (32.4 mph)    
9 km/h (5.6 mph) to
52 km/h (32.4 mph)    
"Machine Underground Speed Limit"    
20 km/h (12.5 mph)    
9 km/h (5.6 mph) to
52 km/h (32.4 mph)    
"Transmission Oil Pressure Sensor" (2)     "Installed" or "Not Installed"     "Installed" or "Not Installed"    
Installed 1    
"Interlock System Engine Shutdown Enable Status"     "Enabled"     "Enabled" or "Disabled"    
( 1 ) The "transmission maximum forward gear" is set to match the setting for the "machine speed limit".
( 2 ) Capable of enabling the sensor or disabling the sensor by using submode 7.7 in the Caterpillar Monitoring System.