PISTON & ROD GP 3172511 - Caterpillar

1. Open the cover of storage box assembly (1), and remove floor mat (2) from storage box assembly (1). 2. Remove four truss head screws (3), three bolts (4), the washers, and storage box assembly (1) from the platform assembly. 3. Remove four truss head screws (7), knob (5), and cover (6) from the transmission control console. Remove the miniature lamp from cover (6). 4. Remove four truss head screws (9) and cover (8) from the transmission control console. 5. Remove two truss head screws (10), ashtray (14), ashtray holder (12), two knobs (13), receptacle cap (15), and cover (11) from the transmission control console. 6. Remove three bolts (17) and the washers from plate assembly (16). 7. Remove three truss head screws (18), the washers, and top cover (19) from the air conditioner. 8. Disconnect wire harness (20) at the electrical connection. 9. Remove three nuts (21) and the washers from blower motor bracket assembly (22). 10. Remove blower motor (23) from air conditioner (24). The following steps are for the installation of the air conditioner blower motor.11. Make sure all components of the blower motor are clean of dirt and foreign material prior to installation. 12. Install blower motor (23) to air conditioner (24). 13. Install three nuts (21) and the washers to blower motor bracket assembly (22). 14. Connect wire harness (20) at the electrical connection. 15. Install top cover (19), three truss head screws (18), and the washers to the air conditioner. 16. Install three bolts (17) and the washers to plate assembly (16). 17. Install cover (11), two truss head screws (10), ashtray holder (12), ashtray (14), two knobs (13), and receptacle cap (15) to the transmission control console. 18. Install cover (8) and four truss head screws (9) to the transmission control console. 19. Install the miniature lamp to cover (6). Install cover (6), four truss head screws (7), and knob (5) to the transmission control console. 20. Install storage box assembly (1), four truss head screws (3), three bolts (4), and the washers to the platform assembly. 21. Install floor mat (2) to storage box assembly (1). Close the cover of storage box assembly (1).End By:a. install seat